cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can subscribe to a forum, label or individual post and receive email notifications when someone posts a new topic or reply. Learn more! X

Sheetmetal: "Bend back" and "Unbend" for conic shapes with chamfers

Sheetmetal: "Bend back" and "Unbend" for conic shapes with chamfers

Status: Archived Submitted by 1-Newbie on ‎Apr 16, 2012 07:24 AM
3 Comments (3 New)

After adding a chamfer to a revolved wall with a shape of a cone, it's not possible to unbend or bend back this wall afterwards, while if the shape is a cylinder instead, this works just fine. The SPR 962955 refers to this problem, and it was created in 2002 (version 2001).It hasn't been resolved yet.

See more ideas labeled with:
3 Comments
DomenicLaritz
16-Pearl
16-Pearl
‎Apr 16, 2012 07:52 AM
‎Apr 16, 2012 07:52 AM

One of the most wanted features for our company!!!

(See also SPR 2114279.)

PTCModerator
Emeritus
‎Jun 14, 2018 04:31 PM
‎Jun 14, 2018 04:31 PM
Status changed to: Acknowledged
 
olivierlp
Community Manager
Community Manager
‎Jan 04, 2022 09:30 AM
‎Jan 04, 2022 09:30 AM
Status changed to: Archived

Hello,

We are archiving your idea as part of a general review. This action is based on the age of your idea and the total number of votes received, as per this announcement.

You can always post a new idea with all the details required in the form.

Thank you for your participation.