cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

The PTC Community email address has changed to community-mailer@ptc.com. Learn more.

The ability to place a Custom symbol on a Surface using the "Normal to Entity" placement type in 3D.

The ability to place a Custom symbol on a Surface using the "Normal to Entity" placement type in 3D.

Status: New Idea Submitted by 6-Contributor on ‎Oct 03, 2019 03:00 AM
1 Comment (1 New)

Currently there is no Placement option for "Normal to Entity" when placing symbols in 3D.

For example, this would be handy when placing surface finishes directly onto dimension witness lines or the applicable surfaces in 3D.

See more ideas labeled with:
1 Comment
GBod
3-Visitor
3-Visitor
‎Oct 03, 2019 03:30 AM
‎Oct 03, 2019 03:30 AM

This would greatly improve the use of surface finish.

In the past PTC advised the use of symbols instead of using the build-in surface finish.