cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about the Community Ranking System, a fun gamification element of the PTC Community. X

Use of multiple assembly models in BOM with connected BOM Balloons.

Use of multiple assembly models in BOM with connected BOM Balloons.

Creo does not allow BOM Balloons to be created when there are multiple models within one table region. Being able to create multiple assemblies within one drawing and labeling each assembly with balloons that are linked to the BOM is a huge time saver. Creo does good job at creating BOM Balloons for single assemblies. If the functionality for single assemblies could be brought into use for multiple assemblies, creating BOMs and BOM Balloons would be immensely easier for drawings containing multiple models.

2 Comments
WayneSchrock
12-Amethyst

This is similar to this idea:

http://communities.ptc.com/ideas/2492

Please vote for both

PTCModerator
Emeritus
Status changed to: Archived