Creo Parametric Ideas

Would be usefull the possibilty to show Item List in the figure like a table or similar. ... View more

Hi,   I find it really difficult and time consuming sometime to find out in what units a measure is given in the creo simulate summary file. Is stress in Pa, kPa, MPa? Is strain energy in J, mJ, kJ and so on. I know this is correlated to the units of the part or assembly but for at least energy it isn't always intuitive how to calculate it. I guess in mmkgs that the energy unit is kg*mm/s^2*mm or micro Joule but I for a while thougth it was Nmm or mJ. Either way it should be really easy to program so that the unit is displayed after the value. I attach a picture to show were I would have wanted it.   Best Regards Jimmie ... View more

Simplify library customization like Symbols (2D & 3D) and Stamps. Now It is very hard to do it.  Furthermore will be usefull: the possibiliy to centralize these libraries like in Creo Parametric the possibility to use different format for 3D Symbols like *.prt, *.step. *.iges. Not only *.ol that is quite unknown!!   ... View more

Drawing templates can only be used during the creation of a new drawing.  It would be very useful to be able to apply a template to a sheet within an existing drawing.  For multi-sheet drawings this would save a lot of work.  On an existing blank sheet, the applied drawing template would use the currently active drawing model and place the views on the sheet.  This would eliminate having to create a new drawing, and then importing it into an existing drawing. ... View more

Create a JT file with a contour from a Creo Simulate fringe plot  ... View more

When a note is added in an Annotation Set, this note should be displayed only in this AnnotationSet, not in all the viewables, as it happens now.   The attached -pdf explains the problem.   Best regards,   Nekane Peña         ... View more

Currently today if you run a Full Report in Interference Detection mode (Using the versus 2 inputs method) It will not state on the report what assemblies you selected.   The report will only list the main assembly (top level assembly) and any two assemblies that reported an interference between each other.   I'd like for the list to also show assemblies with zero quantity interferences as an option. or The general details would simply list the actual assemblies used in the versus input.   See attachment for specific details. ... View more

Installing Creo View will replace any current application for the Creo View file extensions.  Need a way to not overtake certain file extensions (like .tif) by an option screen. ... View more

Drawing view scales are not parametric (and do not respond conveniently) to changes in model geometry.  Use of the "drawing_scale_factor" parameter requires additional 'relations' in part and assembly models, when it should be handled entirely by the drawing.  A 'drawing template view window', that always fits the geometry of the view model (part or assembly), regardless of its orientation, would be a practical tool.  Additionally, an option to specifiy a scale denominator by which the scale is adjusted and still fits inside the view window. ... View more

Enable the export of the Sequence's to 3D PDF.   Currently it is only possible to export an "Animation".   It would be good if it was possbile to go through the Sequence Steps using a PDF reader, since this is a common installed tool (Creo View isn't and Admin rights are needed for installation.)     ... View more

Currently when exporting an image (File -> Save As -> Tiff, Jpg, png) it exports any text that is displayed. Below is an example. It would be nice if if didn't do this or if there was a config option to turn it off.   ... View more

Bonjour, Il parait aberrant  que lors de l'impression d'un plan en pdf ou autre, les axes , plans et autres visualisation soient pris en compte alors qu'il ne s'agit que de visualisation.   ... View more

Add the possibility to edit text in mesure so users can delete or edit prefix (Diameter, Distance, Ecc. Ecc.) or add suffix.  ... View more