Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Check out this video on Creo Simulate Live from PTC Application Engineers
Presenters: Ryan Butcher (Technical Specialist Fellow) and Lino Tozzi (Technical Specialist Fellow)
To dive deeper into the subject, check out PTC University.
Webcast Q&A
Question form Jacob: How much dies it affect performance while running? Does it affect regeneration time or just display related performance?
Answer: CSL uses GPU to solve in a rapid, almost live mode. Only adds a few seconds to regeneration.
Question from Jorge: Does it help for reducing solving time to simplify geometry? For instance, taking out components, features like rounds....
Answer: No, that does not impact performance significantly.
Question from Samarth: Can we add a force convection (like a fan) to this model?
Answer: You would use boundary condition to create an inlet that would act like a fan.
Question from Steven: Is it possible to make an endurance test on simulation live?
Answer: Creo Fatigue Advisor would be used for this.
