Creo and Augmented Reality Tips & Techniques Session Recording (West Coast)

[#1]

Check out this video on Augmented Reality from PTC Application Engineers

Presenters:  Ryan Butcher (Technical Specialist  Fellow) and Lino Tozzi (Technical Specialist  Fellow) 

Original Date Presented:  February 23, 2021  

To dive deeper into the subject, check out PTC University.

[Dayna_M]

Webcast Q&A

Question from Scott:  Is there a way to publish these AR models in a remote environment?  Separate from PTC website or servers?

Answer:  The "Freemium version is only through the PTC Cloud.  There is a solution to bring it to internal to your environment through the full version of Vuforia Studio.  

Question from Scott:  If an added distance is greater than the distance to Target Plane, can you make it float in free space?

Answer:  Yes, it will appear to float.  The target will snap to the floor or table you're setting it on.

[Dayna_M]

Webcast Q&A

Question from Roman:  Do we really need Windchill or can we publish directly from Creo Parametric or Creo View?

Answer:  You don't need Windchill.  You can go directly to Parametric or View.

[Dayna_M]

Webcast Q&A

Question from Bruce:  Can an AR publication be recorded and saved to be circulated and viewed later (i.e. manufacturing, training, service, engineering...processes/procedures)?

Answer:  Those solutions are with our extended suite of AR tools, Vuforia Studio, Expert Capture & Chalk.  https://www.ptc.com/en/products/vuforia

Question from Bruce:  Can multiple AR publications be viewed at once?

Answer:  One experience at a time.

[Dayna_M]

Webcast Q&A

Question from Martinez:  Can the person viewing the model in AR access view states for the model like a section view or exploded view?

Answer:  Yes, that is available in Creo Parametric 7.0.3