Plastic Part Design Tips & Techniques Session Recording (West Coast)

[#1]

Check out this video on Creo Plastic Part Design from PTC Application Engineers

Presenters: Lino Tozzi (Technical Specialist, Fellow) and Ryan Butcher (Technical Specialist, Fellow)

Original Date Presented: November 9, 2021

To dive deeper into the subject, check out Rounds, Ribs, Draft.

[Dayna_M]

Webcast Q&A

Question from Chris:  Are these techniques also preferred for non-plastic parts?

Answer:  Yes, it builds intent intelligence into your design for forthcoming changes.

[Dayna_M]

Webcast Q&A

Question from John:  Do you have a recommended order of feature addition (like bodies, chamfers, drafts, then rounds for eg)?

Answer:  Creation order of those features is not critical any more, based on the auto handling of those features when changes occur.

[Dayna_M]

Webcast Q&A

Question from Marvin:  Are trajectory ribs only available between surfaces, or can the ribs be free standing?

Answer:  Only between surfaces.