cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X

Tool Design/Mold Analysis Tips & Techniques Session Recording (West Coast)

No ratings

Check out this video on Tool Design/Mold Analysis from PTC Application Engineers

Presenters: Lee Goodwin (Technical Specialist, Principal) and Lino Tozzi (Technical Specialist, Fellow)

Original Date Presented: September 14, 2021


To dive deeper into the subject, check out PTC University.

 

(view in My Videos)

Was this tip helpful? Yes No
Comments
Dayna_M
‎Sep 21, 2021 10:23 AM
‎Sep 21, 2021 10:23 AM

Webcast Q&A

Question from Jon:  I'm a member of ASME Y14.8 Castings, Forgings and Moldings.  Would you have any recommendations pertaining to the standard:  good or bad symbols?  Useful concepts such as datum targets?  Short comings to be addressed?

Answer:  I am assuming this is for detailing purposes.  At this moment we support up to ASME Y14.5.

 

Version history
Last update:
‎Sep 20, 2021 12:40 PM
Updated by:
14-Alexandrite
Labels (1)
Labels: