cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

The PTC Community email address has changed to community-mailer@ptc.com. Learn more.

Extract Creo simulate result values using Creo View --> Using Creo simulate OL files

Extract Creo simulate result values using Creo View --> Using Creo simulate OL files

Status: Archived Submitted by 1-Newbie on ‎Aug 14, 2014 11:22 AM
2 Comments (2 New)

Currently we cannot see scalar values of stress/displacement when reviewing an .OL file (created from Creo Simulate run) in Creo View 2.0. Only the 3D stress contour model and legend are shown.

 

Add function to extract values of stress, displacement, or other resultants so non-CAE engineers can review the simulate model in 3D and get a better overall picture of the design.

See more ideas labeled with:
2 Comments
cbittick
1-Newbie
1-Newbie
‎Oct 09, 2015 07:11 AM
‎Oct 09, 2015 07:11 AM

Yes, if using Creo simulate. We can create the .OL file now and can open in Creo View but their is no way of tabulating the high stress/displacement areas. At  least can we add the function of tabulating the values and keeping these so an engineer can review the 3D contour using Creo View without needing Creo Simulate.

PTCModerator
Emeritus
‎Mar 17, 2019 04:12 PM
‎Mar 17, 2019 04:12 PM
Status changed to: Archived