cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

CONSTRAINING PROBLEM

shinoy.sivan
1-Newbie

CONSTRAINING PROBLEM



It's a WF 2- Mechanica story,
The model is shell and using bolts to fasten to ground. For the first
run it's showing insufficiently constraining problem for static
analysis.
But with the same loads, materials and other properties without
touching, and if we go for second run (static only), its running without
any err!!!
Anyone faced this problem ? Does anyone have solution?


Regards,
Shinoy C S




DISCLAIMER:
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements
Attention: Creo 7.0 Customers
Please consider upgrading
End of Life announcement here.

NEW Creo+ Topics:
PTC Control Center
Creo+ Portal
Real-time Collaboration