I have followed the instructions in TPI 132326, but I am unable to open my WF4 part in WF2. The messages I see are:
File C:\temp\fred.prt.2 was created in a newer release of Pro/ENGINEER.
The file C:\temp\fred.prt.2 is not a valid PART file.
'C:\temp\fred.prt.2' cannot be retrieved.
'FRED' cannot be retrieved.
I see the ATB in the file menu in WF2.
I have CRI_grafting_enable set to yes in WF4.
Have you any idea what I may be doing wrong?