Hello,
I have followed the instructions in TPI 132326, but I am unable to open my WF4 part in WF2. The messages I see are:
File C:\temp\fred.prt.2 was created in a newer release of Pro/ENGINEER.
The file C:\temp\fred.prt.2 is not a valid PART file.
'C:\temp\fred.prt.2' cannot be retrieved.
'FRED' cannot be retrieved.
I see the ATB in the file menu in WF2.
I have CRI_grafting_enable set to yes in WF4.
Have you any idea what I may be doing wrong?
WF2 M220
WF4 M180
Thanks,
John
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
