Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X
Hi all,
I would like to know if exist a parameter to set up for not create a fastener file everytime I add a fastner into a assembly.
If I insert a new fastner using IFX, I will have a prt file inside the folder of my project. Is it possible to save all the fastnere that I will use in every assembly in a single folder so is not necessary to re-crate a new file everytime I will insert that fastner in another assembly?
Thanks
Solved! Go to Solution.
Hi,
if you do not have a file management system like Windchill, you can use a search path in Creo where you can store existing files like fasteners and so on.
You find several help files for this in the Help Center.
Here e.g. is an example.
Example: Adding Search Paths (ptc.com)
IFX support such mechanism.
Set the IFX option 'USE_ARCHIVES' to 'YES' and set the IFX option 'PATH_ABS_ARCHIVES' to an existing folder.
General Configuration Options (ptc.com)
Also set a Creo option 'search_path' to this folder.
If you now create new parts with IFX they will automatically be created in the 'PATH_ABS_ARCHIVES' folder.
And if the Creo Option 'search_path' ist set, they will be reused later on if you assemble the same fastener.
If you want to create more than one instance, you can use the IFX 'Instance Creator' to create all instances from one *.dat file.
To Create Library Components (ptc.com)
Hi,
if you do not have a file management system like Windchill, you can use a search path in Creo where you can store existing files like fasteners and so on.
You find several help files for this in the Help Center.
Here e.g. is an example.
Example: Adding Search Paths (ptc.com)
IFX support such mechanism.
Set the IFX option 'USE_ARCHIVES' to 'YES' and set the IFX option 'PATH_ABS_ARCHIVES' to an existing folder.
General Configuration Options (ptc.com)
Also set a Creo option 'search_path' to this folder.
If you now create new parts with IFX they will automatically be created in the 'PATH_ABS_ARCHIVES' folder.
And if the Creo Option 'search_path' ist set, they will be reused later on if you assemble the same fastener.
If you want to create more than one instance, you can use the IFX 'Instance Creator' to create all instances from one *.dat file.
To Create Library Components (ptc.com)
Thanks a lot for your support, it's exactly what I was looking for
Just a question: where I can find the IFX option? There is no USE_ARCHIVE or PATH_ABS_ARCHIVES in my config.pro file
Hi,
you find the IFX options under Tools > Intelligent Fastener > Options.
The Intelligent Fastener group is only available in assembly mode.