cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Load Tool

Highlighted
Newbie

Load Tool

Hello all,

I have written a post for a Toshiba JRV 450N w/Tosnuc 888 control
that works quite well. The only problem that I have is if I run a single
sequence it first preselects the tool changes and then preps the next tool
which is the same number as what it just loaded. This magazine is a double
gripper drum.

This is the output


T1 (lower tool one to waiting position)
M06 (actuate tool change sequnce)
T1 (prep next tool)

This is a problem as the machine alarms out.

Any feedback appreciated.

Kevin Uttley
CAM Programmer
Centerline (Windsor) Ltd.
Automation Components Division.
Windsor, Ontario
(519) 734-8330 x 259
Announcements