cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Orient flat state on a drawing

akok
7-Bedrock

Orient flat state on a drawing

Hi

 

I need to have the flat state placed flat on the drawing, for the lasercutter.

Is there a way to do this?

I'm thinking, create a saved orientation and use this on the drawing.

I doesn't matter how the part is oriented, just it is flat.

 

Allan

4 REPLIES 4
JB_87049
15-Moonstone
(To:akok)

I have made a short video showing you how you can use flat states in a drawing.

It is attached to this message.
Hopefully this is what you are looking for.

akok
7-Bedrock
(To:JB_87049)

Thank you.

 

My problem is, I will like to automate the process you showed.

I will like the get Jlink to first make the flat, here after put the flat on the drawing on sheet 2, orientated flat in 1:1 scale.

 

My problem is I don't know how to orient it flat.

 

Allan

JB_87049
15-Moonstone
(To:akok)

I can not help you with doing that using JLink, but can't you do it using a mapkey?

akok
7-Bedrock
(To:JB_87049)

Proberly I can use a mapkey, do you know how to orient with a mapkey?

Announcements