cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

RE: [draft] RE: True type fonts

Highlighted
Newbie

RE: [draft] RE: True type fonts

Well... I'm revealing my poor memory, but here goes....

First locate your ascii.src file.
(Ours is in C:\ptc\wildfire2\text\usascii)
Locate the ascii.fnt file
(Ours is in c:\ptc\wildfire2\i486_nt\text\usascii\)
Back these files up.

(For the following, replace c:\ptc\wildfire2 with your loadpoint.......)
Open the files with an ASCII test editer such as Wordpad, Notepad, VI,
etc....NOT MS WORD!

Open with Wordpad and change the "I" section to look like this:
"1"
m 8, 16
d 8, 4
m 8, 16 <<< tick start
d 5, 14 <<< tick end

Open with Wordpad and change the "I" section to look like this
"I"
m 8, 16
d 8, 4
m 6, 4 <<< bar start
d 10, 4 <<< bar end
m 6,16 <<< bar start
d 10,16 <<< bar end

Then execute the following (we use a batch file):
c:\ptc\wildfire2\i486_nt\obj\compile_font.exe
c:\ptc\wildfire2\text\usascii\ascii.src
c:\ptc\wildfire2\i486_nt\text\usascii\ascii.fnt

Good luck and I hope the PTC exploder "throbbing brain" out there can
confirm these instruction!

Good luck!

GE Healthcare Technologies
Clinical Systems
Monitoring Solutions
Eric R. Slotty
Mechanical Designer
8200 W. Tower Avenue
Milwaukee, WI 53223
Announcements