I would like to send a thank you to Kurt S., Carol F., Luis C., Mike S., and
Eric H. (and anyone who sends help after this message is sent out) for
helping me on this one.
It is simple, as I expected :
In your drawing setup file, set your min_balloon_radius and
max_balloon_radius to the same value.
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
