Hello friends, We are using Wildfire 2.0 (M100).Here I have a press tool assembly, which I created in assembly module. In this assembly I created one part with assembly references. When I am trying to reassemble this part in the same assembly in different place with placement references, it is picking only assembly references, I am not able to pick any of the component references.... Is there any special configuration setting for this or anybody faced this problem before? I checked reference control....it is kept as "ALL". expecting your reply...... Saju Kannoth Design Engineer Alfanar Moulds Kingdom Of Saudi Arabia
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.