cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

ASSEMBLY CUT USING COPY GEOM WITH TABLE SHELF AS AN ASSEMBLY

Randal1
1-Newbie
1-Newbie
‎May 07, 2018 07:25 AM
‎May 07, 2018 07:25 AM

ASSEMBLY CUT USING COPY GEOM WITH TABLE SHELF AS AN ASSEMBLY

I am trying to cut the leg area out of the shelf.

the leg is copy geometry that i have copied into the shelf asssembly.

is there a way to do an assembly cut using the intersection of the leg (copy geometry)with the shelf assembly??

i am using creo 4.0

 

0 Kudos
Notify Moderator
0 REPLIES 0
Top Tags