Hello!
I'm doing a table where I put coordinates to holes in a model. The table is going to be used for the CNC programming knowing where the hole begin. I have made the holes with the revolve command using a coordinate system to define the "start point".
My problem is when I'm calling for the dimension into the table I only get the value of the dimension. In the textbox I write for an example @d325 and get the measurement. But because I want to show the offset from the default coordinate system I need to get a value that show in wick direction its offset. Positive (235) or negative (-235) offset.
Are there any syntax I can add to my string to show positive or negative offset?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
