Blank dimension in drawing

[ptc-3069067]

Hi all,

Is it possible to create a dimension in a drawing without a visible value?

I know you can replace @D with @S and manually type in your own in text however I would like to remove the 'add1' in the image attached.

Any suggestions would be appreciated!

Thanks,

Craig

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[vmráz · Accepted solution]

Yes it is posssible.

Write @O space. It´s a letter O, not number zero and 1 space afterwards.

See attached picture.

[ptc-5008082]

Change it to @O (letter O) and a space and you will have no numbers (true for WF4 anyway)

[ptc-3069067]

Thanks! I was able to do this with a sketched dimension, not on dimensions created within the model. I wouldn't normally sketch dimensions but it worked for this.