cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

Can you show tolerances with dimension set to show the dim name?

ChrisMcKee
1-Newbie

Can you show tolerances with dimension set to show the dim name?

I am using WF4 M150 and have an issue (nothing new just this time I thought I would inquire) where I would like to apply the use of the real tolerances on a dimension, but the dimension is part of a family table and therefore the display is with the Dimension Name (using @S to replace the dimension value with its name). When you change the Dimension to @S to show the name the visiblity of the Tolerance goes away. Does anyone know if there is a way to show the tolerance when the name is used for display?

Thanks in advance for any assistance.

Chris


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
1 REPLY 1

Hi, Chris Mckee

You can add different tolerance for each instance as shown my attachment. I think your problem solved.

Regards,

Anbarasu G

Top Tags