cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Center Mark - Uniform Sizing?

Highlighted
Granite

Center Mark - Uniform Sizing?

Is there a way I can easily adjust the size of a Center Mark on my Creo 4 drawing besides dragging each endpoint individually?  

Thanks

Tags (1)
12 REPLIES 12

Re: Center Mark - Uniform Sizing?

Under the annotation tab, select the center mark.  Then move your cursor to the intersection of the centerlines and drag from there.  This will drag all four ends at once.

Re: Center Mark - Uniform Sizing?

When I move my cursor to the intersection and try to drag, all I get is a selection box...

Re: Center Mark - Uniform Sizing?

Hi,

please attach a picture describing your "situation".


Martin Hanák

Re: Center Mark - Uniform Sizing?

8-7-2019 7-09-15 AM.jpg

Re: Center Mark - Uniform Sizing?

Select the center mark then position pointer over one of the lines of the center mark and drag the line out from the center to adjust all four ends together.


Creo is an endless adventure: Always more to learn.

Re: Center Mark - Uniform Sizing?

Thanks for the reply... I did what you say but all I get is the selection box, as you can see in the picture above.  

Re: Center Mark - Uniform Sizing?

Once you select the axis (single left mouse button click), you should be able to move the mouse back over the axis and you'll get the 4-arrow pointer, then you can LMB click and hold that will move all of them.axisadjust.jpg


Steve Williams
Pro/E Version 15/16 (Circa 1995/1996)

Re: Center Mark - Uniform Sizing?


@StephenWilliams wrote:

Once you select the axis (single left mouse button click), you should be able to move the mouse back over the axis and you'll get the 4-arrow pointer, then you can LMB click and hold that will move all of them.axisadjust.jpg


Just additional note ...

in doneill's drawing following option is set ... axis_interior_clipping  YES


Martin Hanák

Re: Center Mark - Uniform Sizing?

Ah, I've never used that option, axis_interior_clipping. That makes a mess of my process. I see the same "selection box" as Doneill when that option is set IF I try to select the very center of the axis but I can adjust the "exterior" axis endpoints all at once if I move the mouse over the exterior portion of the axis.

Steve Williams
Pro/E Version 15/16 (Circa 1995/1996)