cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Display subharness only in drawing.

Highlighted

Display subharness only in drawing.

Associates,

I am a relative newbie to the cabling module and I am hoping to
get some assistance. I have created an assembly and added a harness that
has 3 subharness' that are based on the assembly sequence. I am now
creating a drawing of the assembly and I want to show only specific
suharness' in certain views to demonstrate the order in which they have to
be assembled. However, I have tried Drawing Display and View Manager but
have been unsuccessful in showing a single subharness in a drawing view.
Has anyone done this or know how it could be accomplished? I think I
could do it with family tables but that would be a bit messy. Perhaps I
require a different approach for harness creation? Any assistance that
could be rendered would be greatly appreciated.

Dave
1 REPLY 1

RE: Display subharness only in drawing.

For such assembly step representations yu can use Process Plan under File>New>Assembly>Process Plan and then you can call the steps into your drawing file. This module is especially for this purpose.

Ali Akguner