cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

How to create Dimension with Common reference in Creo 6

SOLVED
Participant

How to create Dimension with Common reference in Creo 6

Hello

 

How we could create dimension using common reference in Creo 6 ( in the attached figure it shows for Creo 2)

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Re: How to create Dimension with Common reference in Creo 6

In Creo 4.0 and probably the same in 6.0, select the base reference, then, holding control key, select all other references before placing dimensions.


Creo is an endless adventure: I have learned, created and shared. I will continue learning, creating and sharing,.
3 REPLIES 3

Re: How to create Dimension with Common reference in Creo 6

@MohaSharifi 

Dimension - Common references is o more available as it was merged in Dimension from Creo 3.0. You need to use CTRL for such dimensions. 

Highlighted

Re: How to create Dimension with Common reference in Creo 6

In Creo 4.0 and probably the same in 6.0, select the base reference, then, holding control key, select all other references before placing dimensions.


Creo is an endless adventure: I have learned, created and shared. I will continue learning, creating and sharing,.

Re: How to create Dimension with Common reference in Creo 6

Thanks, yes it needs to select other references while holding the control key before finishing dimensions placement.