cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

How to create the intersection on drawing in pro WF 5.0

Highlighted
Newbie

How to create the intersection on drawing in pro WF 5.0

How to create the intersection on drawing in pro WF 5.0

2 REPLIES 2

Re: How to create the intersection on drawing in pro WF 5.0

Hi

I make for you short video. You can Show model dimensions or Create drived dimensions in drawing, then you can create intersection lines - see here:

Video Link : 1905

Vladimir

Best Regards,
Vladimir Palffy
Highlighted

Re: How to create the intersection on drawing in pro WF 5.0

Another technique you might want to be aware of is the following. If you create that rounded corner inside Sketcher, you can place a Sketcher Point at the intersection of the two lines before adding the Fillet, then dimension to that point. If you do it that way you actually have a dimension that can be Shown as opposed to Created as illustrated in Vladimir's video.

Announcements
Message from Brian Thompson (PTC General Manager and DVP) regarding Creo Business Continuity plans.