cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

How to make representation of interrupted views of cable in drawing?

SOLVED
Visitor

How to make representation of interrupted views of cable in drawing?

Hi,I need to represent a cable in a drawing but with no need to draw the whole length,

so I want to interrupt the cable with zigzag lines,

but,how to operate this in creo?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to make representation of interrupted views of cable in drawing?

In drawing go to the view, properties, visible area, Broken View in the pull down.

jef

3 REPLIES 3

Re: How to make representation of interrupted views of cable in drawing?

There are two methods: Extend across sheet and highway.

To extend across sheet route a fiber from a component/connector port and stop at a point, right click and terminate.  Select Extend Across Sheet command from the Modify menu, pick the end of the wire, select which sheet to extend to, left mouse to start a new fiber, and continue to destination.  You can set this up with a cross sheet graphic at the ends of the wire to show wire information

You can create a highway that wires can attach at a point and then exit at a point simplifying the route across a single sheet.

Thanks,

jef

Highlighted

Re: How to make representation of interrupted views of cable in drawing?

Thanks,Jeff.

Actually,I operate this in creo parametric,in a 2D engineering drawing.

Re: How to make representation of interrupted views of cable in drawing?

In drawing go to the view, properties, visible area, Broken View in the pull down.

jef