cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

How to rename a dimension in sketcher?

SOLVED
Newbie

How to rename a dimension in sketcher?

Can someone tell me how to rename dimensions in sketcher when using Creo 3.0? Apparently if the dimension name is modified to contain the letters DS, then when the model is imported into ANSYS, that software will recognize the dimension as parametric. Seems like a little rename like this should be obvious, but I cannot seem to figure it out.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: How to rename a dimension in sketcher?

Hi,

I think sketcher dimension you can see in Sketcher mode cannot be renamed, they follow default naming scheme sd0, sd1, ...

You can rename model dimensions - see picture.

modeldim.png

MH


Martin Hanák

View solution in original post

3 REPLIES 3

Re: How to rename a dimension in sketcher?

Sketcher doesn't have names for dimensions, just index numbers d1, d4, so on.

The name is changed in the feature that is built from the sketcher geometry by selecting the properties for the dimension. It's in the requester/dialog box at the top.

Re: How to rename a dimension in sketcher?

Hi,

I think sketcher dimension you can see in Sketcher mode cannot be renamed, they follow default naming scheme sd0, sd1, ...

You can rename model dimensions - see picture.

modeldim.png

MH


Martin Hanák

View solution in original post

Highlighted

Re: How to rename a dimension in sketcher?

Thank you Martin, that was the key. It works perfectly.

Announcements
LiveWorx Call For Papers Happening Now!