Community Tip - If community subscription notifications are filling up your inbox you can set up a daily digest and get all your notifications in a single email.
X
I need a hole feature to export as one surface for CAM software.
I use ProE to create all of m fixtures and part models for manufacturing and i have always had an issue with ProE models creating 2 surfaces on hole geometry like 2 180° surfaces or 1/2 cylinders making up the hole cylinder or ID. Is there a config setting for making these export as a one surface entity?
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
Long answer: too long and ends up the same as the short answer., but study up on how BREP models represent surface patches and how those surface patches are used in triangulation to be fed into the GPU pipeline.
