cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Order of BOM balloons & items in table

Visitor

Order of BOM balloons & items in table

Can you control a table and balloon items which can be fixed the same number every time you do a new assembly drawing? E.G part number 001212-08 will always be item 314 in the table and the balloon item and then show the same with QTY underneath.

7 REPLIES 7

Re: Order of BOM balloons & items in table

There is a way to do this with component parameters.  See https://www.ptc.com/en/support/article?n=CS197902

Re: Order of BOM balloons & items in table

After reading your question again I think it might be better to use a 'normal' parameter instead of component parameters.  This would let you set it one time and then display the same value everywhere it's used in any assembly (assuming your repeat region table is set up correctly.)  You would just have to make sure you never reused this same number in any other model or you could end up with duplicate numbers in the same table.

Re: Order of BOM balloons & items in table

This is generally considered a bad idea.

Your example is with a high number, but what about lower numbers, like 1-100?

The 1/4-20X.75 HHCS is to always be item 96?

That would use a lot of numbers if you used a fixed line item for every part.

I have over 2 million parts in Windchill and 11K+ in hardware family tables.

 

Re: Order of BOM balloons & items in table

 

I am not I explained myself very well

 

You place a part list (repeat region) on to the drawing and it the parts in order of part number 1 to 14

 

table start.JPG

You also added Balloons to the drawing driven by the parts list (repeat region)

Balloon start.JPG

To part number 001212-08 to item 313 and 001212-09 to item 314 you have to fix index to be shown like the below image (Which can be done on it's own but the balloon does not change)

What trying to end up with is the below but when ever you bring in a part list at the start it automatically fixes certain part number to certain item numbers and the balloon changes as well.

 

table finish.JPG

 

Balloon finish.JPG

 

What I think I am trying to ask is can fix index before putting a parts list (repeat region) on a drawing?

 

Thank you for your kind help in advance.

 

Re: Order of BOM balloons & items in table

I am only trying to do this on a small amount of numbers which refer to other documents.

 

If you have the same number every time write the other document is a lot quicker to construct.

Highlighted

Re: Order of BOM balloons & items in table

The problem you will have is that you are using 2 different parameters in your BOM table and in the balloons.

The internal find number is being used in the balloons and a normal repeat region.

You will have to do some repeat region relations to get your stored find numbers into the list for parts that have a findnumber and yet use the internal one if they do not.

 

Re: Order of BOM balloons & items in table

Hi Martin

 

I have a common parameter, that I give to any part or assemblies I make.

I called this parameter POSITION.

Then, when I make a repeat region, in one column I set asm.mbr.POSITION.

The repeat region is ordered according this parameter, so balloons too.

In the same drawing, or in other, if I want to have the same number, I just refer to POSITION.

For example, if I put a note or balloon I just have to set "&POSITION" in the string.

Of course, you have to be sure that POSITION are not equal.

 

 

This concept has been explained before by TomU.

I only put an example.

Hope to have been helpful.

Announcements
LiveWorx Call For Papers Happening Now!