1st question: We are using custom Multi-View connectors created from parametric connectors. We have an situation where someone has done a save as on a diagram. We have stripped out most of the previous diagram info. with the exception of renaming a few symbol names which I am not sure how to do without replacing the symbol. Which is the case with a few single view custom connectors. All the info is Ok on the diagram and the wirelist table. The diagram is just holding on to the old symbol names. not worth but so much trouble.
2nd question: One of the multiview connectors is broken into 3 views. One is just spares to the side. I need to use some of the spares now and add a few pins to one of the other connectors. Normally I would add and remove nodes. In this case when I redefine the symbol the pin sequence changes when in the symbol to an incorrect sequence & pins that do not even exist in the partial connector view. I have seen this once before when someone else had worked on a diagram. I am not sure how it what was done. The last time I just re-created the multiview connector. This seems like too much extra work, their must be a way to correct the pins.