cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Red and White Diamond Shape

Highlighted
Participant

Red and White Diamond Shape

Does anyone know what this red and white diamond shape is and how to get rid of it?  I just recently installed M150, Creo 3.0 and it has been there since.  It wasn't there before the install.  It is on my drawing view and model view and is just in the way.  Any help is greatly appreciated.

Red Diamond.JPG

4 REPLIES 4

Re: Red and White Diamond Shape

Are you using a space pilot?

Re: Red and White Diamond Shape

Yes.

Re: Red and White Diamond Shape

That symbol appears while you are spinning the model.  Normally it goes away when you stop but with a space pilot it says visible all the time.  This was discussed previously here on the community but I can't find the topic at the moment.  I believe if you unplug the space pilot it will go away.

Re: Red and White Diamond Shape

This was a known issue and has been corrected in Creo Parametric 3.0 M160 and Creo Parametric 4.0 M040

 

Article 268780