cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Help us improve the PTC Community by taking this short Community Survey! X

Red and White Diamond Shape

jmoran
4-Participant

Red and White Diamond Shape

Does anyone know what this red and white diamond shape is and how to get rid of it?  I just recently installed M150, Creo 3.0 and it has been there since.  It wasn't there before the install.  It is on my drawing view and model view and is just in the way.  Any help is greatly appreciated.

Red Diamond.JPG

4 REPLIES 4
TomU
23-Emerald IV
(To:jmoran)

Are you using a space pilot?

jmoran
4-Participant
(To:TomU)

Yes.

TomU
23-Emerald IV
(To:jmoran)

That symbol appears while you are spinning the model.  Normally it goes away when you stop but with a space pilot it says visible all the time.  This was discussed previously here on the community but I can't find the topic at the moment.  I believe if you unplug the space pilot it will go away.

Mahesh_Sharma
22-Sapphire I
(To:jmoran)

This was a known issue and has been corrected in Creo Parametric 3.0 M160 and Creo Parametric 4.0 M040

 

Article 268780

Top Tags