Creo 4.0 Import Photo or 2D Drawing

[ptc-4068505]

Hi

Is it possible to import a phot or 2D drawing and have on one workplane and on another copy over the photo or drawing ? Is there a good tutorial somewhere, have done some searching with no luck.

Thks

Charlie

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[ptc-4068505]

Hi Everyone

Can someone help me out with this question. I am sure it is a simple procedure, but I have not been able to locate an answer.

our help would be appreciated.

Regards

Charlie

original poster

[ptc-3368773]

Hi charlie,

may be an idea...

I am actually using Cocreate Modeling 17.0 software. To insert a photo or drawing I use the rendering module.

I copy a material and change its texture in the parameters by browing a .pjg file ( or else...).

Just have to scale it afterward.

regards

denis

[ptc-3368773]

browsing and not browing!!!!

[hkramer]

Hello,

you can use the Rendering Module and add a Decal to your part. Add Decal in the rendering module.

this would enable you to add this to your part. (rotation and placements on face is possible)

[ptc-4068505]

Hi

Thanks for the info.

Can you give me a url where the down load for rendering is, for Creo 4

I have searched with no luck.

Thanks

Charlie

[hkramer]

hello,

its part of the professional version of Creo Elements/Direct Modeling. Go to the View Tab or activate it thru Modules..

If you use the Creo Elements/Direct Modeling Express - also known as "Modeling PE" then the Rendering module is not available. See the comapre sheet on the Modeling Express sheet to see the differences.

http://www.ptc.com/WCMS/files/129462/en/6772_Creo_Express_TS_EN.pdf