cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Spur Gear design

Highlighted
Newbie

Spur Gear design

Good afternoon people, Was wondering if any one can help with the design of Spur gears, or if they have the part modeled. I am looking for a 44mm OD and a PCD 38mm standar spur gear, I have been trying varioud methods but can not seem to create a proper mesh between 2 gears. Can any one help with the creation of this part in pro engineer. Thanks
14 REPLIES 14

Involute Gears

http://www.google.com/search?hl=en&q=involute+gears&btnG=Google+Search[/url]

Involute Gears

www.cadquest.com/books/pdf/gears.pdf

RE: Involute Gears

Thanks for the pdf file, that was more of what I required. Thanks again.

RE: Involute Gears

That was a good gear tutorial thanks for posting it. Too bad I didnt have that two weeks ago when I was doing gears. Oh well I made it through.

RE: Involute Gears

I have been struggling with them for a little while now, on my university course. I did find some reference books with help, but I found them very difficult to apply to pro/engineer. I still have yet to design these spurs within pro/e but I am sure it will be an entertaining task.

Pro-E Tips

Also see for Pro-E Tips! http://www.synthx.com/tom/sy_tips.htm

RE: Pro-E Tips

Hi Jonathan, Go through this link. You will have gear models. http://www.mcadcentral.com/proe/files/gallery.asp?action=search Regards, Shankar

RE: Pro-E Tips

Hi people, thanks for the help offered so far, I am still struggling to create a spur gear. Would any one be so kind as to create a spur gear to a set of diemension I give them? So I have a model I can look at and try to investigate how or where I am going wrong. Diemensions are as follows; PCD = 38MM OD = 44mm Module = 1 Thanks if any one can help me further with this. Jon

RE: Pro-E Tips

Bump Can any one help, I am going insane with this.