cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Templates

Highlighted
Newbie

Templates

Hi users,
I have some templates that I created in WF3.0 m040.
I saved various milling and drilling cycles with the
coolant turned on. When I retrieve them the coolant is turned
off. I have created tap cycles with the spot drill,drill and
tap saved as a template for different size taps. I would like
the depth of the spot tool to stay the same so every time I use the
template I get the same chamfer. It is also a bit of a pain to select blind,tip,start surface, z depth, enter depth every time.
Is there a way to do this or at least set the default to come up
blind,tip? Any mouse clicks saved is always helpful. I use a standard drill cycle for spotting as opposed to a chamfer cycle.

Thanks for your help,
Rob J.
1 REPLY 1
Highlighted

re: Templates

Rob,

Not sure about your spot drill size, but the COOLANT_OPTION is now carried as a parameter in the tool and is invoked automatically when you load it.

Regards
Announcements