Hi users, I have some templates that I created in WF3.0 m040. I saved various milling and drilling cycles with the coolant turned on. When I retrieve them the coolant is turned off. I have created tap cycles with the spot drill,drill and tap saved as a template for different size taps. I would like the depth of the spot tool to stay the same so every time I use the template I get the same chamfer. It is also a bit of a pain to select blind,tip,start surface, z depth, enter depth every time. Is there a way to do this or at least set the default to come up blind,tip? Any mouse clicks saved is always helpful. I use a standard drill cycle for spotting as opposed to a chamfer cycle.