Hello!Supposing to have square with hole,I would like to fixe to the ground constraint at the middle...
3 Replies 695 Views
All,I would like to know whether there are any news about the possibility to work several people on ...
HelloI would like to design spur gear with proper pressure angle in Creo 2.0 M080. Could anyone plea...
Hi all! I have a problem with placeing surface finish symbol, on drawings. It works only in free pla...
Morning AllBeen trying to get a 12 mm round on the attached drawing. Tried the surface to surface an...
When I choose a chamfer or countersink callout from model annotations, it currently defaults to ANGL...
Hello,I have created a twisted blade profile using part design, How do I generate the developed draw...
4 Replies 636 Views
I want to measure support force in constrain surface, it's easy to get it in static analysis, but ho...
Hi everyone. I try to use surface future in creo direct modeling. But I don't understand how to use ...
Hello,Has anyone seen this before?The fasteners have incomplete surface regions.The surface regions ...
I'm a novice in Ansys and I'm trying to split a surface to apply a load on a portion of that surface...
I had a discussion with my fellow Mechanical Design Engineers today and we were wondering if there i...
Hi everybody, I am trying to do some customization of drawing frames by pulling information from mod...
by pvanderheijden on 05-02-2018 11:09 PM
0 Replies 356 Views
Hello, I'd like to know how I can create a flat (reference) surface from results of a 3D measurement...
by rkadam on 12-07-2018 11:14 AM
0 Replies 352 Views
Please share critical surfacing in creo 2 to enhance creo 2 use for surfacing Thanks Regards Rohit k...
2 Replies 880 Views
Hi....could any one suggest me that how to find the internal surface area of a part(plastic)
creo analysis inspect geometry how can i use the knots reflection and slop for surfacing
Hi there, Just come across a problem: I've created a sketch and set-up relations between some dimens...
Is there any command in creo to extend 3d projected curve. i know, i can change it by decrease or in...
Ok, this is probably pretty basic, but a user stumped me today with a part which he needs to modify ...
Is there a config setting to default the extrude to remove material instead of adding on? When makin...
5 Replies 951 Views
Is it possible to rotate an surface edge (3D) around an axle? If not - is there any workarounds? Is ...
We are using skeletons to drive a master model design. In turn in that Skelton we have publish geome...
How do I change assembly type from 'Configurable product' to normal 'Design Assembly' in creo?
by ftorabi on 05-02-2018 11:24 PM
0 Replies 211 Views
Hi AllI use Creo 2. I would like to know whether there's a faster (graphic way) to insert a surface ...
5 Replies 2004 Views
I have the impression that a newer version of Creo / Wildfire can always read a prt file from an old...
With the Creo suite of apps the default color scheme uses a white background. We are curious to see ...
I am trying to simulate a thermal analysis for heating a housing on a conduction hot plate sitting o...
6 Replies 2519 Views
I bought Creo 2 a couple of years ago and I now want to use manikins, from child to adult sizes as I...