cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - You can Bookmark boards, posts or articles that you'd like to access again easily! X

Kepware IoT Gateway - Tag ID Separator

nahuel
14-Alexandrite

Kepware IoT Gateway - Tag ID Separator

Hi!

 

When a Tag is configured to be reported by the IoT Gateway, the Tag ID is automatically formatted following below convention:

  • <channel>.<device>.<tag>

Is it possible to change the dot separator for a dash one? So that the Tag ID looks like:

  • <channel>-<device>-<tag>

Regards,

Nahuel

1 ACCEPTED SOLUTION

Accepted Solutions
bchaudhary
17-Peridot
(To:nahuel)

Hi @nahuel ,

 

As far as I know,

  • It is not part of current functionality.
  • However as a Workaround you may introduce a pre-processing step on the receiving side, that would prepare the messages as needed.

Regards

Bhawna

View solution in original post

1 REPLY 1
bchaudhary
17-Peridot
(To:nahuel)

Hi @nahuel ,

 

As far as I know,

  • It is not part of current functionality.
  • However as a Workaround you may introduce a pre-processing step on the receiving side, that would prepare the messages as needed.

Regards

Bhawna

Top Tags