Kepware fail to read the tag from PLC
‎Jan 27, 2024
04:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Jan 27, 2024
04:56 AM
Kepware fail to read the tag from PLC
Hello everyone,
I have a PLC Tag with a 32-bit float address (400188). When I read this using simple Modbus, I obtain a value of 15104753. However, when I configure the same in Kepware, using the float data type with the same address, I see a value of 15116893. I have tried various configurations, but the values still do not match. Please refer to the device settings and suggest a solution for the issue.
Thank you!
Solved! Go to Solution.
Labels:
- Tags:
- debugging
ACCEPTED SOLUTION
Accepted Solutions
‎Feb 06, 2024
11:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Feb 06, 2024
11:46 PM
Hello,
You can try the settings listed below and share your results.
Best Regards,
Bhadresh Rangi
1 REPLY 1
‎Feb 06, 2024
11:46 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Notify Moderator
‎Feb 06, 2024
11:46 PM
Hello,
You can try the settings listed below and share your results.
Best Regards,
Bhadresh Rangi