cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Visit the PTCooler (the community lounge) to get to know your fellow community members and check out some of Dale's Friday Humor posts! X

Use of MID 0008 with Torque tool ethernet driver

PK_9967706
3-Visitor

Use of MID 0008 with Torque tool ethernet driver

Hello,

I am trying to configure Atlas Copco Micro Torque MTF 6000 in Kepware and as per device documentation the MIDs for this device are used differeltly than that of full Atlas Copco Open Protocol. e.g.

 

PK_9967706_0-1715066624813.png

 

My question here is, how should I use the MID 008 to read the last torue value, I know that in device settings there is an option to enable the use of generic subscibe which enables MID 008, but what will be the tag address then for torque value? or it will be same "LTR_TORQUE_VALUE".

(FYI I am a Thingworx developer & have a limited orientation towards industrial protocols & their working)

 

 

1 REPLY 1

@PK_9967706,

 

All you need to do is enable the parameter listed in the following knowledge base article:

 

https://www.ptc.com/en/support/article/CS417352

 

The tag address "LTR_TORQUE_VALUE" would be the same.

 

Thanks,

*Chris

Top Tags