I have one issue left to resolve in a post that I am writing for a dynapath control and was wondering if anyone knew the answer or had any ideas.
When running a G73 breakchip cycle, the dynapath needs the peck depth "K" and also how far it is going to retract after the peck "Q". I was able to set the K value under motion, cycles, cycle deep setting in GPOST, but I cannot seem to find anywhere to set the "Q" value, that sets the retract distance in the G73 cycle. Any ideas?
This is an example of how the code should look, but I am unable to get the Q to output.