cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Did you get called away in the middle of writing a post? Don't worry you can find your unfinished post later in the Drafts section of your profile page. X

CREO7/NC How to set Helical Pitch for Cutline Milling when Milling a Hole

BH_8851954
7-Bedrock

CREO7/NC How to set Helical Pitch for Cutline Milling when Milling a Hole

Hello, All

 

When I use Cutline Milling to mill  a hole, I use Type_Helical , however, I found that I can not set Helical Pitch for Helical milling.

 

Can anyone help me on this issue?

 

 

1 ACCEPTED SOLUTION

Accepted Solutions

Have you tried adjusting STEP_OVER to a smaller value?

View solution in original post

2 REPLIES 2

Have you tried adjusting STEP_OVER to a smaller value?

you are absolutely right, the pitch is controlled by STEP_OVER.

 

thanks for your help!

 

 

Top Tags