Hello Folks,
I was hoping someone had some experience with cobalt chrome. We are
trying to achieve a 8 RMS finish. We are running part on a 5-axis
vertical machine. The part is approximately 1.25" dia x 1" long. Using
oil base coolant. The part geometry is cone shape. We are having some
success but cycle time is a killer. Looking for some recommendations:
1. approach of tool path ( We are starting top to bottom with small
depths)
2.Type and brand of ball mill
3.Speed and feed
4.Coolant
Any advise would be appreciated.
Best Regards,
Frank Vermes
Application Engineer
This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
