cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Face milling sequence.

jarrodmaston
1-Newbie

Face milling sequence.

Hi Gurus! I am milling parts from rectangular to trapezoidal. Using an
anle plate and sin bar to prop the block up, and programming with a "face"
sequence. The workpiece top is at an angle to the face surface. When I
pick "trim to workpiece", it doesn't change the toolpath so the cutter
rapids into the leadin distance. Is there something I'm missing? I'm using
relrase 2001.

Jarrod

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
0 REPLIES 0
Announcements