cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Facing Direction

MDrake
6-Contributor

Facing Direction

I am looking to change the direction the tool moves so that it moves down the face of the part with each pass.

 

It wants to cut in the z direction.  I would like it to cut in the x direction.

 

I believe this yellow arrow has something to do with it.  Is there a way to rotate this arrow?

 

MDrake_1-1605288835561.png

 

1 ACCEPTED SOLUTION

Accepted Solutions
slolli
6-Contributor
(To:MDrake)

Hi, in the parameters for the Face milling toolpath, change the CUT_ANGLE parameter from 0 to 90.

View solution in original post

2 REPLIES 2
slolli
6-Contributor
(To:MDrake)

Hi, in the parameters for the Face milling toolpath, change the CUT_ANGLE parameter from 0 to 90.

MDrake
6-Contributor
(To:slolli)

Thank you!!
Announcements