How to control writing of feed rate to each move line?

[PATAVERY]

Our Milltronics post processor is writing the feedrate to almost every line. It looks something like this:

N00058G3F8.X.6895Y.1057I.0197J-.0035

N00060G1F8.X.9139Y.0662Z.13

While our FADAL posts something like this for the same part

N0280G3X.6895Y.1057I.0197J-.0035

N0290G1X.9139Y.0662Z.13

Where is the "toggle" in the Gpost generator to turn writing the feedrate to each line on and off?

I cannot seem to locate it.

This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.

[AustinN.C.,Inc. · Accepted solution]

There are a few things you can check.  Open the post in the Option File Generator and go to the Machine Tool Type -> Type, Specs & Axes -> Specs page.  In the top right see what the setting is for Motion Register Modality.  If it is set the the second option you will get F codes on every block.

Fred

[PATAVERY]

Thanks Fred. I knew it was in there somewhere. I hope all is well with you.