cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Community Tip - Learn all about PTC Community Badges. Engage with PTC and see how many you can earn! X

How to control writing of feed rate to each move line?

PATAVERY
1-Visitor

How to control writing of feed rate to each move line?

Our Milltronics post processor is writing the feedrate to almost every line. It looks something like this:

N00058G3F8.X.6895Y.1057I.0197J-.0035

N00060G1F8.X.9139Y.0662Z.13

While our FADAL posts something like this for the same part

N0280G3X.6895Y.1057I.0197J-.0035

N0290G1X.9139Y.0662Z.13

Where is the "toggle" in the Gpost generator to turn writing the feedrate to each line on and off?

I cannot seem to locate it.


This thread is inactive and closed by the PTC Community Management Team. If you would like to provide a reply and re-open this thread, please notify the moderator and reference the thread. You may also use "Start a topic" button to ask a new question. Please be sure to include what version of the PTC product you are using so another community member knowledgeable about your version may be able to assist.
ACCEPTED SOLUTION

Accepted Solutions

There are a few things you can check.  Open the post in the Option File Generator and go to the Machine Tool Type -> Type, Specs & Axes -> Specs page.  In the top right see what the setting is for Motion Register Modality.  If it is set the the second option you will get F codes on every block.

Fred

View solution in original post

2 REPLIES 2

There are a few things you can check.  Open the post in the Option File Generator and go to the Machine Tool Type -> Type, Specs & Axes -> Specs page.  In the top right see what the setting is for Motion Register Modality.  If it is set the the second option you will get F codes on every block.

Fred

Thanks Fred. I knew it was in there somewhere. I hope all is well with you.

Announcements


Top Tags