cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

How to set the Planar machining of Gpost?

mrao
8-Gravel

How to set the Planar machining of Gpost?

Hi programmer,

 

my problem is how to generate correct coordinate and C axis in tap file?

 2017-8-29 上午 11-33-56.jpg

I use Mill-Turn type machine to do side machining of part which machine has y axis function (Like above picture shown). However, I have setup "planar machining" in my post file which included I defined output code for G1 and defined C axis of "Option for ABC angle output", but Creo always generated "G1 C0" when planar machining has different angle.

 2017-8-29 上午 11-18-02.jpg

 

 

Also I found that Mill-Turn type need to define Z axis direction for Horizontal of coordinate setting which setting different with 4 axis Mill type (Z axis is Vertical), therefore, Creo refer to sequence coordinate then cause Creo generated wrong coordinates in tap file.

 2017-8-29 上午 10-54-56.jpg

2017-8-29 上午 11-03-24.jpg

Have a good day!!

Mark Rao

 

0 REPLIES 0
Announcements