cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Showing results for 
Search instead for 
Did you mean: 

Ptc Creo and embeded basic Moldex 3d capabilities in every seat

kerzen
5-Regular Member

Ptc Creo and embeded basic Moldex 3d capabilities in every seat

Dear All,

In PTC Creo 3.0 Launch Presentation from June 17, 2014 Brian Thomson announced that New basic capabilities from Moldex 3d will be embedded in every seat of Creo Parametric. I have installed Creo 3.0 M10 and there is no such analysis. Only what i can access is 3d thickness Check. I was told that i need to buy PTC Creo Mold Analysis Extension, why if they said in every seat?. Please check PTC Creo 3.0 Launch Presentation at time 34:28 Where Brian Thomson said " every body gets it". I was rely looking forward of this functionality. Did i missed something? Can someone give me answer please.

A1.jpg

Best Regards

Klemen

1 ACCEPTED SOLUTION

Accepted Solutions
kerzen
5-Regular Member
(To:kerzen)

Hi, there is some update on this issue

First; You need to upgrade your licence for free to enable Mold Analysis Lite.

Second; When you do that you get enabled Mold Analysis Lite

Third; What is enabled in Mold Analysis Lite is useless.

Hope that in future Lite versions will be more useful.

Best Regards

Klemen

View solution in original post

9 REPLIES 9

If it is installed you may need to enable the lite version extension by turning it on in the config.pro file like some of the other light extensions (simulate lite, human factors, etc) It may not be implemented yet in Creo 3 ?

kerzen
5-Regular Member
(To:danderson)

Hi Don,

No there is no such config pro. I ve checked.

It is implemented in 3.0 in M10.

Best Regards

Klemen

Hi Klemen,

Yes, this became available with Creo 3.0 M010, but there is an additional requirement that you need to update your license pack.

There is a new license pack line item called Mold Analysis Lite that PTC should be adding to every customer's license pack automatically (for those on support).

All the details are here: https://support.ptc.com/appserver/cs/view/solution.jsp?n=CS187881

Regards,

Allan

I wonder if that is why I cannot find the Manufacturing Lite module in my Creo 2.0.

kerzen
5-Regular Member
(To:kerzen)

Hi, there is some update on this issue

First; You need to upgrade your licence for free to enable Mold Analysis Lite.

Second; When you do that you get enabled Mold Analysis Lite

Third; What is enabled in Mold Analysis Lite is useless.

Hope that in future Lite versions will be more useful.

Best Regards

Klemen

Isn't it supposed to be available via Applications- Mold Analysis? Mine is still greyed out even though the Mold Anaysis Lite is shown in System information under configured license options.

Mold+Analysis+Lite.jpg

kerzen
5-Regular Member
(To:magnus.salomons)

Hi Magnus,

Did you install it?

Thanks Klemen...I did not....forgot about the options during installations.

Missing IntelMPI might be a reason too.

https://www.ptc.com/en/support/article?n=CS187138

 

Announcements